Setup; Flushing; Quick Start-Up Guide - Graco Tradeworks 150 Operation Manual

Warnings

SETUP

1
Remove spray tip and guard from gun.

FLUSHING

1
Turn Pressure Control Knob left (counterclock-
wise) to minimum pressure.
4
WASTE
If spraying oil-based materials,* submerge
suction tube in paint thinner or compatible
oil-based cleaning solution.
If spraying water-based materials, submerge
suction tube in water.
6

QUICK START-UP GUIDE

WARNING WARNING WARNING
2
Connect hose to gun and sprayer.
2
Project Painter
Turn Spray/Prime valve to PRIME.
5
ON
Turn Power switch ON. With Spray/Prime
valve still at PRIME, turn Pressure Control
Knob to right (clockwise) until pump starts.
3
OFF
Turn Power Switch OFF. Plug sprayer into
grounded outlet.
3
150/170
Unclip small drain tube from large suction tube
and place into waste pail.
6
WASTE
Allow fluid to flow out of prime tube, into waste
pail, for 30 to 60 seconds. turn power switch
OFF.
WASTE
PAINT
313381L