Cleaning Gun - Graco Tradeworks 150 Operation Manual

Shutdown and Cleaning
Step 16 is for returning paint in hose back to paint
pail. One 50-ft (15-m) hose holds approximately
1-quart (1-liter) of paint.
16. To preserve paint in hose:
a. Point gun into paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn Prime/Spray valve to SPRAY.
150/170
e. Turn power switch ON.
f. Continue to hold gun trigger until you see paint
diluted with water starting to come out of gun.
17. While continuing to trigger gun,
quickly move gun to redirect
spray into waste pail. Continue
triggering gun into waste pail
until water coming out of gun is
relatively clear.
18. Stop triggering gun. Engage trigger lock.
26
ti8909a
ti13960a
ti12938a
Project Painter
ti5580a
ti8908a
19. Turn prime/spray valve to Prime.
150/170
20. Turn power switch OFF.
21. Turn off garden hose. Close Power Flush attach-
ment.
22. Unscrew Power Flush attachment from suction tube.
23. Clean InstaClean Fluid Filter and gun, page 26.
24. Fill unit with Pump Armor
Term Storage, page 27.

Cleaning Gun

• Clean gun fluid filter (d)
with water or flushing sol-
vent and a brush every
time you flush the system.
ti12942a
Replace gun filter if dam-
aged.
• Remove tip and guard and
clean with water or flush-
ing solvent. A soft brush
can be used to loosen and
remove dried on material if
needed.
• Wipe paint off outside of
gun using a soft cloth
moistened with water or
flushing solvent.
ti12941a
Project Painter
ti2810a
ti9413a
ti2047a
™
storage fluid. Read Long
ti13961a
d
ti9671a
313381L