Install Tip And Guard On Gun - Graco Tradeworks 150 Operation Manual

11. Transfer suction tube to paint pail and submerge
suction tube in paint.
ti9653a
12. Turn power switch ON.
ti5580a
13. When you see paint coming out of prime tube:
a. Point gun into waste pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn Prime/Spray valve to SPRAY.
ti12938a
150/170
NOTE: Some fluids may prime faster if the Power
Switch is momentarily turned off so the pump can
slow and stop. Repeat several times if necessary.
14. Continue to trigger gun into waste pail until you see
only paint coming out of gun.
15. Release trigger. Engage trigger lock.
ti8908a
313381L
ti8909a
ti13960a
Project Painter
16. Transfer prime tube to paint pail and clip prime tube
to suction tube.
• Motor stopping indicates pump and hose are
primed with paint.
• If motor continues to run the sprayer is not
properly primed. To reprime, turn Prime/Spray
valve to PRIME and repeat step 12.

Install Tip and Guard on Gun

1. Engage trigger lock.
ti8908a
2. Verify tip and guard parts are assembled in order
shown.
retaining nut
guard
tip
Use tip to align seat
in guard
ti12966a
3. Screw tip and guard assembly on gun. Tighten
retaining nut.
black rubber gasket and
metal seat
ti12969a
Tip must be pushed
all the way into guard
ti12961a
Setup
ti1270a
19