Power Flush - Graco Tradeworks 150 Operation Manual

Power Flush

Power flushing is a faster method of flushing. It can only
be used after spraying water-based coatings.
1. Relieve pressure, page 16.
2. Remove tip and guard assembly from gun and place
in waste pail.
3. Place empty waste and paint pails side by side.
4. Lift suction tube and prime tube from paint pail. Let
them drain into paint for a while.
5. Place suction and prime tube in waste pail.
6. Turn Pressure Control knob to the Prime/Clean set-
ting.
7. Screw power flush attachment to garden hose.
Close valve.
8. Turn on water. Open valve. Rinse paint off suction
tube, prime tube and inlet screen.
9. Turn lever to close power flush attachment.
ti9413a
313381L
ti9726a
ti12940a
ti9413a
10. Unscrew inlet screen from suction tube. Place inlet
screen in waste pail.
ti2040a
11. Connect garden hose to suction tube with Power
Flush attachment. Leave prime tube in waste pail.
ti2042a
12. Turn power switch ON.
ti5580a
13. Open lever on Power Flush attachment.
ti2043a
14. Circulate water through sprayer, into waste pail, for
20 seconds.
15. Turn power switch OFF.
ti2018a
Shutdown and Cleaning
25