Aperture Priority Mode - Sekonic L-608 CINE Operating Manual

5. Measurement

1-2 Aperture Priority mode

1. Hold down the Mode set button ! 0 and turn the Set/change
dial to select aperture priority mode.
2. Turn the Set/change dial t to set the desired
f stop value.
3. Press the Measuring button ! 5 to make a
measurement.
Release the Measuring button to complete the
measurement. The measured value (shutter
speed) at the time will be displayed.
While pressing the Measuring button, the
meter measures continuously until it is
released.
Reference:
・ It is possible to switch between 1, 1/2 or 1/3 F stop values by setting DIP switch 4.
・ You can set f stops from F0.5 to F161 (full f stops)
・ The measured shutter speed is displayed in 1/2 stops in the liquid crystal dot display.
With the 608 Cine, values are displayed in 1/3 stops.
・ After measurement, the shutter speed corresponding to the F stop is displayed when the
F stop is changed.
-14-
MODE
Measured value
(shutter speed)
Set f stop value
Measured shutter speed
1/10
f stop