Table of Contents
Advertisement
6.
Upon setting completion, the Radio flash mode is selected using the Set/change dial while the
mode button is depressed.
7.
Confirm that the unit and the radio wave receiver are set to the same channel number. The
flash unit will fire when the measurement button of the unit is pressed and measurements can
be made at the same time.
Reference:
• Refer to the receiver instruction manual for the receiver operating method.
• Maximum controllable distance of the radio flash trigger system differs depending on the
placement of the device, direction and other factors.
1.
Confirm the direct visible range between the transmitter and receiver.
2.
Place the devices away from large metal objects, concrete, objects with large moisture
content (both people and trees fall into the category) and so forth.
3.
Secure the radio wave receiver module in place by using Velcro tape or a tripod hole.
Be sure that the entire length of the receiver antenna is higher than the flash pack at
this time. Avoid contact between the receiver antenna and metal objects at all times.
4.
Depending on the location, there may be cases when the receiver is incapable of
receiving any radio signals whatsoever.
There are various possible reasons for this such as radio signals reflected from nearby
objects. This can generally be resolved by shifting the device slightly in one direction
or another.
In addition, confirm that the device is not placed behind objects that readily absorb or
deflect radio signals such concrete, metal, low hills, etc.
NOTE:
• The radio flash system may be used only in countries where a permit for the control
frequency has been issued by the government office in charge.
6. Advanced Functions
-37-
Advertisement
Table of Contents
