Aperture Priority Mode - Sekonic FLASHMATE L-308X Operating Manual

NOTE
● Use Custom Setting to display shutter speed step increment in full,1/2 or 1/3 step
increment ( ➡ P31).
● Shutter speed can be set from 60 sec. to 1/8000 sec.
● After the measurement, the aperture value will be automatically adjusted to maintain
proper exposure when changes in shutter speed and/or ISO are made.
● If "E.o" (over) or "E.u" (under) appears and blinks, the measurement cannot be made at
the selected settings ( ➡ P29).
5-1-2

Aperture Priority Mode

Operation
1.
Press the MODE Button to select the
Aperture Priority Mode.
2.
Hold ISO Button and press UP or
DOWN Button to select the ISO
sensitivity ( ➡ P13).
3.
P r e s s t h e U P B u t t o n o r D O W N
Button to set the desired aperture.
4.
Press the MEASURING Button to
take a measurement. Measurements
will be taken continuously and
displayed as Shutter Speed as long
as the button is pressed. Releasing
the MEASURING Button will hold
and display the last measured value.
NOTE
● It is possible to switch between full, 1/2 or 1/3 F stop values with the custom setting
mode ( ➡ P31).
● You can set aperture from 0.5, 0.56, 0.63, ......4.0, 4.5, 4.8, 5.0, 5.6, 6.3, 6.7, 7.1, 8.0, 9.0,
9.5, 10, 11,13, 14, 16, 18, 19, 20, 22......64, 72, 76, 81, 90.
● If "E.o" (over) or "E.u" (under) appears and blinks, the measurement cannot be made at
the selected settings ( ➡ P29).
MODE Button
MODE
ISO Button
Measured value
(shutter speed)
15
5. Measurement
UP Button
DOWN Button
1/10 shutter speed
Set f stop value
●