Applying Factory Default Values - Raymarine STV Gen2 Installation And Operation Manual

3. Press YES to display the STEP AZ control screen.
4. Use the CCW or CW soft keys to step the antenna
counter-clockwise or clockwise, to the required horizontal
direction. The horizontal angle is displayed on the top line.
5. When you have set the required horizontal direction, press the
EL soft key to display the STEP EL control screen.
6. Use the DOWN or UP soft keys to step the antenna, to the
required horizontal direction. The vertical angle is displayed on
the top line.
7. To leave the antenna move step mode, press the EXIT soft key
to return to the ANT MOVE STEP? screen.
System operation and setup

3.4 Applying factory default values

Use this procedure to return all settings to the factory default values.
With the ACU in setup mode:
1. Press the PREV softkey until SET DEFAULT? is displayed.
2. Press YES.
The message DEFAULT SETTING is displayed and the
parameter values are reset. When the procedure is complete,
the SETUP MODE? entry screen is displayed.
3. Press either:
• YES if you want to change the setup values, or
• NO to re-initialize the system using the default settings.
37