Raymarine STV Gen2 Installation And Operation Manual page 25

Changing the target satellite
Your satellite system can be set up to track either two or three
default satellites, depending on your geographical location. The
name of the satellite the system is currently tracking is shown in
the top line of the ACU display.
TRACKI NG A: AS T RA2
System with 2 default satellites
TRACKI NG A: AS T RA2
B: HOT BI RD TURKS AT
T RACKI NG C:
AS TRA2
System with 3 default satellites
To change the default satellite, press the left hand soft key. The
default satellite changes and is automatically tracked by the
antenna.
System operation and setup
T RACKI NG A: HOT BI RD
B: AS TRA2 S ET UP
T RACKI NG B: HOTBI RD
T URKS AT AS T RA2
TURKS AT
HOTBI RD
Monitoring antenna operation
With the system switched on and running, the ACU display shows
the current status of the antenna. This can be either:
• TRACKING - the antenna is tracking the satellite
• SEARCH - the antenna is looking for the satellite
• UNWRAPPING - the antenna is unwrapping cable
You can check the details of the satellite position by pressing the
center soft key:
• Once to see the elevation
• Twice to see latitude, longitude and signal strength
• Three times to return to the normal operating display
Setting sleep mode
If the antenna looses the tracking satellite whilst in sleep mode,
sleep mode is cancelled. To register a key on your remote control to
access sleep mode see 'Setting the remote control'.
1. Press Back to access sleep mode.
2. Press Back again to exit sleep mode.
T RACKI NG A: AS TRA2
B: HOTBI RD S ET UP
T RACKI NG A: AS TRA2
B: HOT BI RD S ET UP
29