BASIC OPERATION
2.06.03 Generating CTS
GENERATE
Modulation
This field will accept any selected frequency from 0.1Hz to 999Hz, so non-standard tones may
be used.
Example: To enter a new CTS frequency of 78.5Hz, press
The tone may be toggled on and off by pressing
Property of Ramsey Electronics, Inc.
To enter a deviation value, press
Do not reproduce or distribute.
to select the FM field; the icon will blink. To enter a deviation of 300.0Hz, press
Standard CTS deviation is typically 0.75 kHz. Deviation values range from 0.1Hz to 2.5 kHz.
You can set a step/increment value for deviation in the CTS deviation field by pressing the
arrow buttons to test tone decoder sensitivity. To cancel out of either entry press
To generate a CTS tone, press CTS. Current
TX Level
parameters are now shown on the display. To
enter a new CTS tone you will need to know
its frequency, not the tone #. Use the chart at
Seq/Reg
the end of the manual for standard CTS tones.
20