Summary of Contents for Ramsey Electronics Interface Board Kit IB1
Page 1
INTERFACE BOARD Ramsey Electronics Model No. Ever want to spy on a friend or an enemy without them knowing it? Well now you can with the IB-1. It is small enough that it can easily be hidden, yet it picks up audio as well as video! The Interface board picks up infra-red light, allowing it to be used at night or in dark places.
Page 2
Write or call for our free Ramsey catalog. Ramsey Electronics publication NO. MIB1 Rev. 1.5a COPYRIGHT 1994 by Ramsey Electronics, Inc. 590 Fishers Station Drive, Victor, New York 14564. All rights reserved. No portion of this publication may be copied or duplicated without the written permission of Ramsey Electronics, Inc.
Introduction: It is now possible to monitor what is happening at night as well as during the daylight hours with the Interface board kit and a camera. By virtue of infrared LEDs for night vision and a microphone attached to an amplifier circuit, you can use it to spy on someone or as a means of added security.
IB1 Parts List: t is a good idea to check off the components in the boxes provided and to separate them as you go along. This will save hunting for specific components later. RESISTORS 470 ohm resistors [yellow-violet -brown] (R8, R9) 1K ohm resistors [brown-black-red] (R1,R4) 10K ohm resistors [brown-black-orange] (R2, R3, R7) 22K ohms resistors [red-red-orange] (R5, R6)
Page 7
CONSTRUCTION OF THE IB1 INTERFACE BOARD KIT 1. Install J2 and J3, the RCA style audio and video jacks, on the PC board. These require some heat for the solder to flow so take your time. 2. Install J1, the power jack. 3.
13. Connect your camera. Follow the wiring diagram on the paperwork enclosed with your camera. OPTIONAL If you are planning on using the Interface board at night or in dark areas you will want to install R10 and R11 along with infrared LEDs. The brightness desired can be changed by using more or less IR LEDs.
SET-UP: The IB1 is designed to be powered by an external power supply using jack J1. A 12 to 15 volt regulated DC supply is recommended, with the “center” pin of the connector being the positive or the (+) connection. 1.
CONCEALMENT IDEAS: There are many places that the Interface board and a small CCD camera (check the Ramsey catalog or website at www.ramseykits.com) can be hidden because of their size and maneuverability. The best place for you depends on your application and what type of setting it is to be used in. The Interface board and a camera could be used to watch the children, for security outside as well as inside, or to capture the 10 thousand dollar home video.
But on rare occasions a sour component can slip through. All our kit parts carry the Ramsey Electronics Warranty that they are free from defects for a full ninety (90) days from the date of purchase. Defective parts will be replaced promptly at our expense.
Digital Multimeter Ramsey M133 Price: $5.00 Ramsey Publication No. IB1 Assembly and Instruction manual for: RAMSEY MODEL NO. IB1 INTERFACE BOARD KIT RAMSEY ELECTRONICS, INC. 590 Fishers Station Drive Victor, New York 14564 Phone (585) 924-4560 Fax (585) 924-4555 Introduction to the IB1 ... 4 How It Works ...