Signal Status - Raymarine GPS navigation Operation Manual

3.10.2 Signal Status Pages
The
T
SIGNAL STA US
acquisition and tracking of the attached sensors and thereby indicate the
quality of the position fix. If the
sensor, the status of the sensor in use is always displayed. You may choose
GPS or Loran operation while in the normal Display modes by pressing the
k e y .
3.10.2.1 Loran Signal Status
When operating in the Loran-C mode and
pressed, the first screen advises which type of "stats" you will be looking at.
The
"LORAN STATUS"
STATUS MENUS
LORAN C STATUS
STATUS MENU IF LOWN
I
On this display the characters show the selected GRI and the Secondaries
being received and used for L/L calculations in the Signal box (prominently
featured on the page). The Master (M) station is shown first in the box. As
each Secondary signal is received it becomes listed in the box. The signals
appear in the list in the order in which they are received and not necessarily
in numerical order.
The selected GRI number appears in the top section of the box. An "A" may
appear to the right of the GRI to indicate that the 508 sensor is operating in
the automatic GRI and secondary selection mode. If the "A" is not ON, the
sensor is in the "manual" Station selection mode.
OPERATION 336
displays are used to show the conditions of signal
unit is using both a loran and GPS
NAV
screen will appear as shown in the figure below.
ENTER
TOGGLES
ENTER TO GElURN I