Editing Route Plans - Raymarine GPS navigation Operation Manual

When-is pressed the route sequence mode, will be ON. The route
number will be displayed in the left corner of the waypoint information bar
on the POS, NAV, or CD1 screens and the first point of the route plan
becomes your initial destination, unless you happen to already be at the first
point of the route.
While you are following the route plan you may press themlkey
anytime to bypass the next point in the route plan.
Turning the Route OFF
The route plan can be conveniently turned OFF anytime by pressing the
One other method of turning the route sequence to OFF is a bit indirect but
if you press thdmlkey to select any waypoint that is not part of the route
plan, or press ml, OJm , the route will be turned OFF.

3.9.3 Editing Route Plans

The EDIT ROUTE mode is used to
plan or to ERASE a route plan in its' entirety.
Press the /ROUTE/51 key. Press thelm[ softkey. when the EDIT ROUTE
Selection screen appears, select the route number you 1
wish to edit. Press//[
On the EDIT ROUTE screen the route legs can be
examined and the bearing and distance of the high-
lighted leg of the route plan displayed. If changes are
necessary, you can insert or delete waypoints in the B
legs in a route by performing the following key opera- 1
tions:
The EDIT ROUTE display shows the Route # and
the leg containing the first two waypoint #'s in the
route. To see other waypoints in the legs of the route,
of interest in the highlighted block to check the bearing
and distance.
the FOLLOW ROUTE screen press the
or waypoints in a route
INSERT DELETE
SELECT ROUTE NUMBW
OPERATION 3-33
EDIT ROWE
I