Power Cords - Alcatel-Lucent OmniSwitch 9800E Hardware User's Manual
Omniswitch 9000e series
Hide thumbs
Also See for OmniSwitch 9800E:
- Management manual (312 pages) ,
- Network configuration manual (1162 pages) ,
- Cli reference manual (3706 pages)
Table of Contents
Advertisement
Power Cords
Power Cords
Because the power cord is the power supply's main disconnect device, it should be plugged into an easily
accessible outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Specifications
The power cord to be used with 115-Volt configuration is a minimum type SJT (SVT) 14/3, rated at 250
Volts AC, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug
and the other end terminates in a NEMA 5-15P plug.
The power cord to be used with 230-Volt configuration is minimum type SJT (SVT) 14/3, rated 250 Volts
ac, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug and the
other end terminates as required by the country where it will be installed.
European cords must be Harmonized (HAR) type.
Important. The specified replacement power cord for OmniSwitch 9000E Series switches is 14-gauge
(14/3). Do not use standard 18-gauge (18/3) cords such as those supplied with personal computers.
DC-to-DC Power Cords
For DC-to-DC connections, refer to
page 2-28
page 2-16
for additional guidelines and information.
OmniSwitch 9000E Series Hardware Users Guide
Chassis and Power Supplies
December 2008
Advertisement
Table of Contents
