Fixed Glass Assembly; Install The Decorative Front; Air Shutter Setting - Heat & Glo SLR-D Owner's Manual

F. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front.
2. Locate the two spring latches that are on the upper
left and right of the fireplace.
3. Use both index fingers to release spring latches. See
Figure 14.5.
4. Allow glass to tilt forward. Grasp glass on the upper
right and left sides and lift glass "up" and "out."
Replacing Fixed Glass Assembly
1. Locate glide tabs on lower left and right corners.
2. Grasp glass on upper right and left sides and tilt bot-
tom of glass assembly toward fireplace.
3. Allow of the bottom gasketing of the glass assembly
to touch the face of the fireplace.
4. Put pressure on the glass as you allow the glass
assembly to drop into the two lower glass clips. See
Figure 14.5.
5. Tilt top of glass towards fireplace and engage both
top spring latches.
UPPER SPRING LATCH
LOWER GLASS CLIP
Figure 14.5 Fixed Glass Assembly
G. Install the Decorative Front
WARNING! Risk of Fire! Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts could cause fireplace to overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative front.
H. Air Shutter Setting
Air shutter settings may be adjusted by a qualified install-
er at the time of installation. The air shutter is set at the
factory for minimum vertical vent run. Adjust air shutter for
longer vertical runs. See Figure 14.6.
• Loosen the 1/4 in. screw.
• Twist shutter to adjust
• Shutter may be opened for longer horizontal vent runs.
• Do not close the air shutter more than the settings
• Tighten the screw.
NOTICE: If the flames appear to be orange, open the air
shutter to prevent residue buildup on the glass.
Heat & Glo • SLR-D • 2333-900 Rev. F • 9/17
specified below.
Figure 14.6 Air Shutter
Air Shutter Settings
SLR-D
NG LP
3/16 in. 9/16 in.
61