Appliance Preparation; Top Vent - Heat & Glo SLR-D Owner's Manual

9

Appliance Preparation

A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
ELBOW HEAT SHIELD SHOWN
IN SHIPPING POSITION
Figure 9.1 Elbow Shield Shown as Shipped
If venting with a 90 degree elbow directly off of the top of
the appliance, the elbow heat shield must be repositioned
as shown in Figure 9.2.
If not venting with a 90 degree elbow, remove the elbow
heat shield and discard by removing the two 1/4 in. screws
that secure the elbow heat shield to the top of the fireplace.
For all venting applications, ensure that the pipe gasket is
in place before attaching any pipe section. This gasket is
shipped in place around the starting collar. See Figure 9.2.
Heat & Glo • SLR-D • 2333-900 Rev. F • 9/17
ELBOW HEAT SHIELD
SHOWN AS INSTALLED
PIPE GASKET
Figure 9.2 Elbow Shield Shown Installed
39