Sample Cluster Upgrade - Cisco MDS 9216 Configuration Manual
Mds 9000 series san volume controller
Hide thumbs
Also See for MDS 9216:
- Hardware installation manual (140 pages) ,
- Connection manual (13 pages) ,
- Specification (11 pages)
Table of Contents
Advertisement
Upgrading Clusters
•
•
If all the checks succeed in Step 1 the upgrade process begins.
Verify that cluster upgrade has succeeded by issuing one of two commands in SVC configuration mode:
Step 2
•
•
Sample Cluster Upgrade
switch(svc)# show node local
-------------------------------------------------------------------------------
Node
-------------------------------------------------------------------------------
svc3/1
svc3/2
svc7/1
svc7/2
switch(svc)# cluster name SampleCluster upgrade svc-system
scp://userc@171.69.16.22/auto/andusr/userc/hkrel/VegasSW/build/gdb.sb-avanti/isan/targetfs
/m9000-ek9-csm-svc-mzg.1.3.x.bin
userc@171.69.16.22's password:
m9000-ek9-csm-svc-mz 100% |***************************************|
The cluster upgrade process has initiated successfully when the prompt returns.
Note
switch(svc)# show node local
-------------------------------------------------------------------------------
Node
-------------------------------------------------------------------------------
svc3/1
svc3/2
svc8/1
svc8/2
In this example, node svc4/1 has completed upgrade to the new version of the svc software.
Cisco MDS 9000 Family SAN Volume Controller Configuration Guide
8-4
If all the nodes in the cluster are running the same level of code and all nodes are present.
If the new SVC software image has been successfully transmitted to all the nodes in the cluster.
the show node local command—Ensure that the node software version corresponds to the new node
software version.
the show cluster SampleCluster nodevpd command—Ensure that the software upgrade complete
event message is in the supervisor syslog.
Config Cluster
Cluster
node
SampleCluster
SampleCluster
SampleCluster
SampleCluster
Config Cluster
Cluster
node
SampleCluster
SampleCluster
SampleCluster
SampleCluster
status
No
active
No
active
Yes
active
No
active
status
No
active
No
active
Yes
active
No
active
Chapter 8
Upgrading CSM Software
Node
Sw
status
version
active
1.3(1)
active
1.3(1)
active
1.3(1)
active
1.3(1)
108 MB
Node
Sw
status
version
active
1.3(x)
active
1.3(1)
active
1.3(1)
active
1.3(1)
78-16119-01, Cisco MDS SAN-OS Release 1.3
01:23
Advertisement
Table of Contents
