Control Box - Grizzly G0727 Owner's Manual

Control Box

Use Figure 13 and the descriptions below it to
better understand the functions of the control box
components.
D
C
B
Figure 13. Control box components.
A. Master Power Switch Cover. Lifts to expose
the ON and OFF buttons and enables the use
of the STOP button.
B. STOP Button. When pressed, pushes the
OFF button underneath the cover to turn the
mill OFF.
C. STOP Button Tab. When pressed, allows
the master power switch cover to be raised
to expose the ON and OFF buttons.
D. Master Power Switch ON/OFF Buttons.
Enables/disables power to the spindle
motor.
E. Overload Lamp. Illuminates if the spindle
motor is overloaded. When overloaded, the
motor stops. To re-start the motor, turn the
spindle speed dial counterclockwise to set
a minimum speed, adjust the operation to
reduce the load, then press the ON button.
F. Machine Fuse. Prevents thermal overload
damage.
Model G0727 (Mfg. Since 7/11)
E
F
G
H
A
G. Power Lamp. Illuminates when power is
enabled to the spindle motor with the master
power switch.
H. Spindle Speed Dial. Controls the speed of
spindle rotation between 200–2000 RPM.
Table Movement
Table movement is controlled by handwheels and
moves in the three directions shown in Figure 14.
X-Axis (Logitudinal)
or Left & Right
Z-Axis (Vertical) or
Up & Down
Z-Axis
Y-Axis
Figure 14. Table movement.
Y-Axis
(Cross Feed)
or In & Out
X-Axis
-19-