Installing/Removing
Tooling
The Model G0769 includes a
MT#2 arbor (see Figure 110).
Figure 110.
⁄
" chuck joined with MT#2 arbor.
1
2
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Installing Tooling
Tools Needed
Wrench 8mm ..................................................... 1
Wrench 17mm.................................................... 1
Wrench 25mm ................................................... 1
To install tooling:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove drawbar cap (see Figure 111).
Drawbar Cap
Figure 111. Location of drawbar cap.
Model G0768/G0769 (Mfd. Since 8/15)
⁄
" drill chuck with
1
2
Qty
3.
Insert tooling into spindle until in contacts
drawbar.
4.
Working from top, thread drawbar by hand
into tooling until it is snug (see Figure 112).
Figure 112. Threading drawbar into tooling.
5.
Tighten drawbar.
Note:
Do
not
Overtightening makes tool removal difficult
and will damage arbor and threads.
6.
Tighten drawbar lock nut, as shown in Figure
113.
Figure 113. Tightening drawbar lock nut.
7.
Re-install drawbar cap.
overtighten
drawbar.
Drawbar
Locknut
-65-