Inventory - Grizzly G0727 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Small Item Inventory: (Figures 3–4)
A. Horizontal Arbor Support Assembly ........... 1
B. Arbor Support Gib ...................................... 1
C. Horizontal Arbor w/Spacers ........................ 1
D. Chuck Arbor R8-JT33 ................................ 1
E. Drill Chuck JT33 1–13mm .......................... 1
F. Chuck Key .................................................. 1
G. Spindle Rod ................................................ 1
H. T-Nuts M10-1.5 ........................................... 2
I. Adjustable Foot Assemblies ....................... 4
J. Combo Wrench 21/24mm ........................... 1
K. Combo Wrench 14/17mm ........................... 1
L. Combo Wrench 12/10mm ........................... 1
M. Combo Wrench 5.5/7mm ........................... 1
N. Hex Wrench Set 3, 4, 5, 6mm ........... 1 Each
O. Spanner Wrench 22/26mm ........................ 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
-12-
Qty
Figure 3. Machine accessories.
O
Figure 4. Tools and adjustable feet.
A
B
C
E
G
F
J
K
I
L
M
N
Model G0727 (Mfg. Since 7/11)
D
H