Table of Contents
Advertisement
Telemetry function (FASSTest 18CH mode only)
To use the telemetry function, set "Telemetry" to
"ACT".
DL Interval (FASSTest 18CH mode only)
When a telemetry function is enabled, the
receiving interval (down-link interval) of sensor
data can be changed.
If a DL interval is increased, the response of
the sensor data display becomes slower, but stick
response will improve.
System Type selection procedure
1. Move the cursor to the [FASSTest-18CH] item
and push the RTN button to switch to the
data input mode.
2. Select the system type by scrolling the edit
dial.
[FASSTest 18CH][FASSTest 12CH]
*An example of selections for each system is on the following
page.
3. Push the RTN button to end adjustment and
return to the cursor mode.
Dual receiver function (only FASSTest 18CH
mode) procedure
1. Move the cursor to the [SINGLE] item and
push the RTN button to switch to the data
input mode.
2. Select the [SINGLE] or [DUAL] by scrolling the
edit dial.
ID of a Primary
receiver displays.
ID of a Secondary
receiver displays.
In DUAL, a primary receiver is link previously.
Next, a secondary receiver is link.
3. Push the RTN button to end adjustment and
return to the cursor mode.
Telemetry ACT/INH procedure
1. Move the cursor to the TELEMETRY [ACT] item
and push the RTN button to switch to the
data input mode.
2. Select the [ACT] or [INH] by scrolling the edit
dial.
3. Push the RTN button to end adjustment and
return to the cursor mode.
DL Interval set procedure
1. Move the cursor to the TELEMETRY DL [1.0s]
item and push the RTN button to switch to
the data input mode.
2. Select the DL time by scrolling the edit dial.
If a DL interval is increased, the response of
the sensor data display becomes slower, but
stick response will improve.
Initial value: 1.0s
Adjustment range : 0.1s~2.0s
3. Push the RTN button to end adjustment and
return to the cursor mode.
<Functions of Linkage Menu>
55
Advertisement
Table of Contents
