Table of Contents
Advertisement
SERVO MONITOR
This is used for testing servo movement.
"Moving Test" (repetition mode) and "Neutral
Test" (fixed position mode) are available.
The "Neutral Test" is good for finding the
neutral position of a servo horn.
● Select [SERVO MONITOR] at the linkage menu and call the
setup screen shown below by pushing the RTN button.
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
Servo test operation
1. Use the edit dial to move the cursor to the
[TEST] item and push the RTN button to switch
to the data input mode.
Select the test mode by turning the edit dial
to the left or right and push the RTN button.
[MOVING]: Mode which repeats operation of
each servo
[NEUTRAL]: Mode which locks each servo in
the neutral position
2. Use the edit dial to move the cursor to the
[TEST] item and push the RTN button to switch
to the data input mode.
Select the [OFF] by turning the edit dial and
push the RTN button. Testing is stopped.
50
<Functions of Linkage Menu>
Servo Test & Graph Display / Displays servo positions.
*The display screen is an example. The screen
depends on the model type.
In order to prevent any potential difficulties,
the servo test function will be inoperable, or
inaccessible, under certain conditions. Specifically,
the Servo Test function is not operational if the
Throttle Cut is ON in either airplane or helicopter
modes; or if the Throttle Hold is ON in Helicopter
mode.
S1
WARNING
Don't set a servo test mode when the drive
motor is connected and the engine is powered
or running.
■ Inadvertent rotation of the motor or acceleration of the
engine is extremely dangerous.
<Edit dial>
Scrolling
● Moving cursor
● Selecting mode
Advertisement
Table of Contents
