Juniper SRX550 Manual page 8

3. Configure the security topology:
a. Internet zone (Untrust)
b. Internal zones (Trust)
c. DMZ
4. Configure the security policy:
a. Licenses (Security services)
b. DMZ policy
c. Internet and internal policies
d. Remote VPN
5. Configure Network Address Translation:
a. Internal Source NAT
b. Internal Destination NAT
c. DMZ Destination NAT
How to Set Up Your SRX550 High Memory Services Gateway
6. Review the settings and click Apply Settings.
NOTE: Check the connectivity from the management device to the
SRX Series device. You might lose connectivity to the SRX Series device
if you have changed the internal zone IP. Click the URL for reconnection
instructions on the Confirm & Apply page to reconnect, if required.
7. Click Done to complete the setup.
Configure the Device Using the Default Setup Mode
NOTE: Verify that the management device is connected to port 0/1 on
the services gateway before proceeding to the next step.
1. Configure the basic settings – device name, root account information, and
system time.
8