Juniper SRX550 Manual page 7

Configure the Device Using J-Web
To configure the device using J-Web, follow the steps in this section.
1. Enter the root authentication password.
2. Select one of the following setup modes:
• Guided Setup (uses a dynamic IP address)—Allows you to set up the
device in a custom security configuration. You can select either the Basic
or the Expert option.
• Default Setup (uses a dynamic IP address)—Allows you to quickly set up
the device with the default configuration. Any additional configuration can
be done after the wizard setup is completed.High Availability—Allows you
to set up a chassis cluster with a default basic configuration.
• High Availability—Allows you to set up a chassis cluster with a default basic
configuration.
NOTE: The initial configuration requires that you specify the device
name and root password. You can skip all the other steps and go directly
to the Confirm & Apply page to apply the configuration.
How to Set Up Your SRX550 High Memory Services Gateway
Configure the Device Using the Guided Setup Mode
1. Select the expertise level as Basic or Expert.
The following table compares the Basic and Expert levels:
Options Basic
Number of internal zones 3
allowed
Internet zone configuration • Static IP
options
• Dynamic IP
Internal zone service Allowed
configuration
Internal destination NAT Not allowed
configuration
2. Configure the basic settings:
a. Device name
b. Password for the root account (Use the password that you entered in Step
1 of the "Configure the Device Using J-Web" section.)
c. Time
Expert
≥ 3
• Static IP
• Static pool
• Dynamic IP
Allowed
Allowed
7