Factory Default Settings - Juniper SRX550 Manual

Factory-Default Settings
Security Policies
Source Zone Destination Zone
trust untrust
trust trust
NAT Rules
Source Zone Destination Zone
trust untrust
Interfaces
Port Label Interface
0/0 and 0/9 ge-0/0/0 and
ge-0/0/9
0/1 ge-0/0/1
0/2 ge-0/0/2
0/3 ge-0/0/3
0/4 ge-0/0/4
0/5 ge-0/0/5
cl-1/0/0
dl0
* Only if the LTE Mini-PIM is present
Services
Services
SSH
HTTPS
NETCONF over SSH
Policy Action
permit
permit
Policy Action
Source NAT to untrust zone
interface
Security Zone DHCP State
untrust Client
trust Server
trust Server
trust Server
trust Server
trust Server
untrust
How to Set Up Your SRX550 High Memory Services Gateway
Protocols
Protocols
RSTP (all interfaces)
Screens
Screens
Basic set of screens are enabled on the untrust zone
Device Startup Mode
Device Startup Mode
Switching
Initial Configuration Process
IP Address
Unassigned
Install Device
192.168.1.1/24
in a Rack
192.168.2.1/24
192.168.3.1/24
192.168.4.1/24
Verify the
Settings
192.168.5.1/24
ISP Assigned*
NOTE:
www.juniper.net/documentation/hardware/safety-guide/translated/index.
html.
Connect the
Grounding Cable
Configure
Using ZTP/J-Web
Management Device
Before you begin the installation, see the Safety Guide at
Power On
the Device
Connect to
https://
2