Verify The Settings - Juniper SRX550 Manual

2. Configure the security policy – licenses.
3. Review the settings and click Apply Settings. Click Done to complete the
setup.
You can also configure the services gateway using the CLI, by connecting to
the Console port. For details, see the
Hardware Guide.

Verify the Settings

Access http://www.juniper.net to ensure that you are connected to the Internet.
This connectivity ensures that you can pass traffic through the services gateway.
SRX550 High Memory Services Gateway
How to Set Up Your SRX550 High Memory Services Gateway
If the page does not load, perform the following checks to see if you can identify
the problem:
• Verify your configuration settings, and ensure that you have applied the
con figuration.
• Check if the ISP-supplied device connecting your SRX Series device to the
Internet is turned on and working properly. Try turning it off and on again.
After you complete these steps, the SRX Series device can pass traffic from any
trust port to the untrust port.
Change the Configuration Settings (Optional)
After you complete the initial setup configuration, you can access the J-Web
setup wizard by clicking Configure > Device Setup > Set Up. You can either
edit the existing settings or create a new configuration. If you choose to create
a new configuration, then all the current configuration in the services gateway
will be deleted.
9