Removing The Display Assembly; Prerequisites; Procedure - Dell XPS 15 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1 Remove the base cover.
2 Remove the I/O-board interposers.
3 Remove the heat sink.
Procedure
1 Open the latch and disconnect the camera cable from the system board.
2 Peel the camera cable from the palm-rest and keyboard assembly.
3 Peel the tape that secures the display-cable bracket to the system board.
4 Remove the two screws (M1.6x1.8) that secure the display-cable bracket to the system board and lift the bracket off the system
board.
5 Using the pull tab, disconnect the display cable from the system board.
6 Remove the two screws (M2x4) that secure the wireless-antenna bracket to the I/O board and lift the bracket off the I/O board.
7 Disconnect the antenna cables from the I/O board.

Removing the display assembly

computer. After working inside your computer, follow the instructions in After working inside
www.dell.com/
Removing the display assembly
23
45