Programming; Conditions Of Program Examples - Mitsubishi Melsec-A AJ65SBT User Manual

5 PROGRAMMING

5 PROGRAMMING
This chapter explains the programming of the AJ65SBT-CLB.
When applying any of the program examples introduced in this chapter to the actual
system, verify the applicability and confirm that no problems will occur in the system
control.
Refer to the user's manual of the master module for details of that module, to Section
3.7 for the remote registers, and to the AnSHCPU/AnACPU/AnUCPU/QCPU-A (A
Mode) Programming Manual (Dedicated Instructions) for details of the dedicated
instructions.

5.1 Conditions of Program Examples

The program examples in this chapter are based on the following conditions.
(1) System configuration
AJ65SBT-CLB (Station No. 1)
Terminating resistor
Power supply adaptor
5 - 1
PLC CPU
Master station (X0 to X1F/Y0 to Y1F)
I/O (64 input points) (X20 to X5F)
I/O (64 output points) (Y60 to Y9F)
Number of occupied stations setting (CC-Link side) : 2 stations
Transmission speed setting (CC-Link side)
Point mode setting (CC-Link/LT side)
Transmission speed setting (CC-Link/LT side)
General power supply
Remote I/O station
(Station No. 1)
CL2X8-D1C3V
Input module
(X400 to X407)
24VDC
MELSEC-A
: 156kbps
: 4-point mode
: 156kbps
Remote I/O station
(Station No. 3)
CL2Y8-TP1C2V
Output module
(Y408 to Y40F)
Terminating resistor
5 - 1
5