Programming; Programming Procedure - Mitsubishi AJ65BT-64DAV User Manual

5. PROGRAMMING

5. PROGRAMMING
The programming procedure, basic read/write programs, and program examples for the
AJ65BT-64DAV/DAI are described.
When applying any of the program examples introduced in this chapter to the actual system, verify the
applicability and confirm that no problems will occur in the system control.
Refer to the user's manual of the master module used for the master module, to Section 3.6 for the
remote registers, and to the AnSHCPU/AnACPU/AnUCPU/QCPU (A mode) Programming Manual
(Dedicated Instructions) for details of the dedicated instructions.
5.1

Programming Procedure

Create programs for executing the digital-analog conversion of the AJ65BT-64DAV/DAI in the
following procedure.
5
*1 When using the QCPU (Q mode), you can use the remote device station initialization procedure
registration function to make settings. When using the ACPU, QCPU (A mode) or QnACPU, use
the sequence program to make settings.
*2 The remote device station initialization procedure registration function cannot be used to make
settings.
Use the sequence program to make settings.
Start
Select factory-set/user-set
values for the offset and gain
Set the analog output enable/prohibit
Set the digital value
Set the D/A conversion enable or prohibit
o m p l e t i o n
5-1
MELSEC-A
Initial value setting*1
*2
*3