Using The Program - Extron electronics FOX SW8 MM User Manual

Using the Program

NOTE:
1
Figure 9.
Activating a USB port for the first time
The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard
appears (figure 8). Activate the connected USB port for your device as follows:
NOTE:
1.
Select the
2.
Select the
Follow the on-screen instructions. The wizard assigns the driver necessary to access the
switcher to the connected Configuration (USB) port (this may take a few minutes).
3.
Click Finish
4. Proceed to
Instruction Set™
NOTE:
The first time you connect to the Configuration (USB) port, the Found New
Hardware Wizard appears (see figure 9). See
first time," below.
For other connections, proceed to
1
Found New Hardware Wizard
If you have not installed the latest Universal Switcher Control Program
(version 4.1 or newer), click
Reconnect the computer to the Configuration port on the switcher.
radio button and click
No, not this time
Install the software automatically
to exit the wizard.
"Starting the program" on the next page or return to the
Control" section.
You may need to repeat these steps if you subsequently connect the
switcher to a different USB port on the same computer.
"Activating a USB port for the
"Starting the program," on the next page.
2
Cancel , install the program, and reboot the PC.
.
Next
radio button and click
FOX SW8 • Remote Control
2
Next .
"Simple
14