Level 1-2 Service Manual
Removing and Replacing the Board-to-Board FPC Connector
1.
Remove the battery door, battery, front housing cover, upper PCB, receiver, camera-
module FPC connector, flush-light FPC connector, rear housing cover, carrier antenna,
vibrator connector, daughter board, vibrator, lower PCB, keypad, rubber stopper, and cover
hinge FPC as described in the procedures.
2.
Have a right angle between the front housing and the rear housing and then remove the
board-to-board FPC connector from the phone as shown in Figure 28.
Board-to-Board
FPC Connector
Figure 28. Removing the Board-to-Board FPC Connector
3.
To replace, press the board-to-board FPC connector into place.
4.
Replace the cover hinge FPC, rubber stopper, keypad, lower PCB, vibrator, daughter board,
vibrator connector, carrier antenna, rear housing cover, flush-light FPC connector, camera-
module FPC connector, receiver, upper PCB, front housing cover, battery, and battery door
as described in the procedures.
December 22, 2004
Disassembly
33