Disassembly
Removing and Replacing the Upper PCB
24
1.
Remove the battery door, battery, and front housing cover as described in the procedures.
2.
Disconnect the board-to-board FPC connector from the upper PCB as shown in Figure 12.
Board-to-Board
FPC Connector
Figure 12. Disconnect the Board-to-Board FPC Connector
3.
Lift the upper PCB up and away from the front case as shown in Figure 13.
Figure 13. Removing the Upper PCB
4.
To replace, align the upper PCB to the front case and press it into place.
5.
Connect the board-to-board FPC connector to the upper PCB.
6.
Replace the front housing cover, battery, and battery door as described in the procedures.
December 22, 2004
MPx220