Motorola MPx220 Service Manual page 32

Level 1-2 Service Manual
4. Remove the lower PCB from the rear housing by lifting the board-to-board FPC connector
up and away from the back side of the lower PCB as shown in Figure 25.
Board-to-Board
FPC Connector
Figure 25. Removing the Lower PCB
5. To replace, connect the board-to-board FPC connector to the back side of the lower PCB.
6. Place the keypad below the lower PCB.
7. Align the lower PCB to the rear housing, allowing the hooks on each side of the lower PCB
to snap into position.
8. Replace the vibrator, daughter board, vibrator connector, carrier antenna, rear housing
cover, flush-light FPC connector, camera-module FPC connector, receiver, upper PCB,
front housing cover, battery, and battery door as described in the procedures.
December 22, 2004
Disassembly
31