Connection - Icom IC-R2500 Instruction Manual

PRECAUTION
RWARNING! NEVER
254L to an AC outlet. This may pose a fire hazard or result in an elec-
tric shock.
RWARNING! NEVER
vehicle. Safe driving requires your full attention— anything less may
result in an accident.
NEVER
connect the receiver to a power source of more than 14 V
DC. This will damage the receiver.
NEVER
connect the receiver to a power source using reverse po-
larity. This will damage the receiver.
NEVER
cut the DC power cable between the DC plug and fuse
holder. If an incorrect connection is made after cutting, the receiver
may be damaged.
NEVER
expose the receiver to rain, snow or any liquids. The re-
ceiver may be damaged.
NEVER
operate or touch the receiver with wet hands. This may
result in an electric shock or damage the receiver.
NEVER
place the receiver where normal operation of the vehicle
may be hindered or where it could cause bodily injury.
NEVER
let objects impede the operation of the cooling fan on the
rear panel.
AVOID
using or placing the receiver in direct sunlight or in areas
with temperatures below –10°C (+14°F) or above +60°C (+140°F).
connect the receiver via the OPC-
operate the receiver while driving a
BE CAREFUL!
The receiver will become hot when operating it
continuously for long periods.
AVOID
setting the receiver in a place without adequate ventilation.
Heat dissipation may be affected, and the receiver may be damaged.
AVOID
the use of chemical agents such as benzine or alcohol
when cleaning, as they can damage the receiver's surfaces.
For U.S.A. only
CAUTION:
Changes or modifications to this device, not ex-
pressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
ii