Heat Sink - HP ENVY 17m Maintenance And Service Manual

Heat sink

Description
Heat sink
IMPORTANT:
replacement
Before removing the heat sink, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
c. Hard drive (see
d. Solid-state drive (see
e. Memory (see
f. WLAN module (see
g. Optical drive (see
h. System board (see
Remove the heat sink:
1. Remove 7 screws holding the heat sink (1) to the system board.
Make special note of each screw and screw lock size and location during removal and
Base enclosure on page
Battery on page
Hard drive on page
Solid-state drive on page
Memory on page
WLAN module on page
Optical drive on page
System board on page
26).
28).
31).
33).
35).
37).
39).
50).
Spare part number
925478-001
Component replacement procedures 53