Attach Mount; Level Mount; Lock Mount; Attach Telescope - iOptron AZ Mount Pro Instruction Manual

3.3. Attach Mount

Carefully position telescope mount onto the tripod by aligning the three holes on the bottom of
the mount base to the three level adjustment screws on the top of the tripod.
Thread the tripod bolt into the bottom of the mount while holding the mount with your hand.
Slightly tighten the tripod bolt by turning the tripod bolt lock knob.

3.4. Level Mount

Adjust level adjustment screws to level the mount using the bubble level on the base. You may
use a torpedo level on the opposite side of the bubble level to assist the leveling.

3.5. Lock Mount

Tighten the bolt lock knob to secure the mount. Slide tripod
support spreader onto the bottom of bolt. Position the three edges to
fit against the three tripod legs. Then hand tighten tripod lock knob
to secure the tripod support spread in place.

3.6. Attach Telescope

Attach a telescope to dual dovetail saddle. Make sure that the telescope objective end is
pointing to the direction as the arrow mark on the dovetail pointed to. The dovetail saddle can be
Figure 5 Attach mount
Figure 6 Level mount
12
Figure 7 Lock mount