Alcatel Speed Touch Wireless User Manual page 107

Configuring PPTP
profiles
3EC 17766 AAAA TCZZA Ed. 01
Field Description
HDLC In order to cope with these PPP frame differences, the
STWireless adapts to the different formats on a 'per
Framing
connection' base.
(continued)
Additionally, the STWireless offers the following PPP/AAL5
format configuration options via the CLI if interoperability
problems should arise (See section 7.5 for more information):
Value
Never
Always
Keep
Note: This configuration possibility applies only to the upstream
direction ! In the downstream direction, the STWireless will
always make sure that FF 03 is in front of the frame prior to put
it in a PPTP tunnel.
State Indicates the connection state of the active PPTP connection. It
can take following values:
Value
Resolving
Retry
In Use
User
Indicates the IP address of the host, i.e. PC, using this PPTP
connection
PPTP profiles can be configured via the CLI.
See section 7.5 for more information.
7 Data Services - PPPoA to PPTP Relaying
Description
The STWireless will make sure that
FF 03 will never be found in front of a
PPP frame encapsulated on a
AAL5/ATM connection, independent of
the actual format of the PPP frame in
the tunnel. This setting is default, and
follows RFC2364.
The STWireless will make sure that
FF 03 is always in front of a PPP frame
encapsulated on an AAL5/ATM
connection. Although not supported by
RFC2364, some equipment may rely
on this format.
The STWireless will not change the
PPP frame arriving via a tunnel.
Description
The PPTP entry is setting up the
connection.
The PPTP entry did not succeed in
connecting to the remote side, and is
retrying.
A user opened a session on this PPTP
entry.
107 / 362