11 SERVICE WORK ON THE CHASSIS
11.42
74
S02045-10
Checking the rubber grips
401197-01
E00265-10
Main work
–
Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve
body side by side behind the handlebars and above the
fuel tank bracket. Both throttle cables must be secured
behind the rubber band of the fuel tank contact area.
»
If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
Finishing work
–
Install the fuel tank.
(
–
Mount the seat. (
p. 60)
–
Install the air filter box cover. (
–
Install the right side cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
1
Check that screw
is firmly seated.
Guideline
Screw, fixed
M4
grip
A
The diamond
must be located at the top.
p. 67)
p. 61)
p. 65)
5 Nm (3.7 lbf ft)
®
Loctite
243™