Checking The Rubber Grips - Husqvarna FC 450 Rockstar Edition 2022 Owner's Manual

11.45

Checking the rubber grips

SERVICE WORK ON THE CHASSIS 11
Main work
–
Check the throttle cable routing.
Both throttle cables must be routed, side by side, on the
back of the handlebars and above the fuel tank bracket,
to the throttle valve body. Both throttle cables must be
secured behind the rubber strap of the fuel tank support.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
A01106-10
Finishing work
–
Install the fuel tank.
–
Install the right side panel. (
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
figure.
F03684-10
( p. 71)
p. 52)
p. 64)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
must be positioned visibly as shown in the
Loctite ® 243™
79