Motion Setup - Q-See Q25DVR4ES User Manual

Chapter 5: DVR Setup -
MOTION SET
MOTION RECORD TIME:
MOTION ALARM TIME:
MOTION SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU)
MOTION SET
CHANNEL 1 SENSITIVITY
CHANNEL 2 SENSITIVITY
CHANNEL 3 SENSITIVITY
CHANNEL 4 SENSITIVITY
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER (SELECT)
PRESS (MENU)
CHANNEL AREA SET:
Press " Select" to enter the sensitive area of each camera. The picture of the selected channel is
divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press [UP] to move
up, press [DOWN] to move down, press [
When the block is transparent, it's active to record. When the block is covered by shadow, it is not
active, and motion in this area will NOT be recorded.
Make sure Record Schedule is set to Motion for the times required.
After completing the "MOTION SETUP", User can exit by clicking [
and press [ Record] to start Motion Recording.
Q-See Q25DVR4ES User's Manual
10
OFF
TO EXIT
4
4
4
4
TO EXIT
Select] to set the block to being active or not.

5.14 Motion Setup

MOTION RECORD TIME:
This number indicates how long the
triggered recording lasts after the DVR
has been triggered by motion.
MOTION ALARM TIME:
This number indicates how long the
buzzer inside the DVR will sound when a
motion event has been detected.
MOTION SET:
User needs to have video record method
set to Motion Trigger. (Refer to 5.7
Schedule Set)
CHANNEL SENSITIVITY:
Press [
motion detection on each channel.
High (1----------9, OFF) Low
When it's OFF, the channel cannot be
triggered by movement.
Page 14
Select] to adjust sensitivity of
Menu],