Video Loss; Other Alarm - Q-See QT428 User Manual

MAIN MENU SETUP GUIDE

4.5.3 Video Loss

Step 1: Enter into system configurationalarm configurationvideo loss; refer to Fig 4-26:
Step 2: The setup steps of video loss trigger are familiar with alarm handling; user can refer to Chapter 4.5.1 Sensor
alarm handling for more details.
Step 3: User can setup all channels with same parameters, checkmark "all", then to do relevant setup.
Step 4: Click "default" button to restore default setting; click "apply" button to save the setting; click "exit" button to
exit current interface.

4.5.4 Other Alarm

Step 1: Enter into system configurationother alarm; refer to Fig 4-27:
Step 2: select a hard disk in the pull down list box, when the disk capacity is lower than that value, there will
appear some text information on the lower right of the live image.
IP conflict: if there is an IP address conflict within the same network, the device will auto send an email to
users designated mailbox to notify the conflict details.
Fig 4-26 Alarm Configuration-Video Loss
Fig 4-27 Other Alarm
33 | P a g e
QT428 User Manual