Q-See QT428 User Manual page 35

MAIN MENU SETUP GUIDE
Step 5: In the Area interface, user can drag slide bar to set the sensitivity value (1-8), the default value is 4. The
higher the value the higher sensitivity you get. Since the sensitivity is influenced by color and time (day or night),
user can adjust its value according to the practical conditions; click
click icon, the set detection area will be cleared; click
motion area are suitable to current conditions（refer to following picture）; Click
icon, exit current interface.
Note: when user drags mouse to set motion detection area, they have to click
current detection area first, and then set the area.
Step 6: User can setup all channels with same parameters, checkmark "all", then to do relevant setup.
Step 7: Click "default" button to restore default setting; click "apply" button to save the setting; click "exit" button to
exit current interface.
② Schedule
Step 1: Enter into system configurationalarm configurationschedule; refer to Fig 4-25:
Step 2: The setup steps of alarm schedule are similar to schedule; user can refer to 4.4.1 Schedule for details.
icon, user can test whether the sensitivity value and
Fig 4-25 Alarm Configuration-Schedule
32 | P a g e
QT428 User Manual
icon, set the whole area as detection area;
icon, to save the setting; click
icon to clear