Alarm Out - Q-See QT428 User Manual

MAIN MENU SETUP GUIDE
Disconnect: if the disconnect happen, the device will auto send disconnection information to users
designated mailbox.
Step 3: Click "default" button to restore default setting; click "apply" button to save the setting; click "exit" button to
exit current interface.

4.5.5 Alarm Out

Alarm out includes three sub menus: alarm out, schedule and buzzer
① Alarm out
Step 1: Enter into system configurationalarm out; refer to Fig 4-28:
Step 2: In this interface, set relay alarm out name, select hold time which means the interval time between the two
consecutive alarms.
Step 3: User can setup all channels with same parameters, checkmark "all", then to do relevant setup.
Step 4: Click "default" button to restore default setting; click "apply" button to save the setting; click "exit" button to
exit current interface.
② Schedule
Step 1: Enter into system configurationschedule;
Step 2: The setup steps of alarm out schedule are similar to schedule; user can refer to 4.4.1 Schedule for details.
Note: the default schedule of motion detection is all of the time, that is, the color of schedule interface is all
blue.
③ Buzzer
Step 1: Enter into system configurationbuzzer;
Step 2: Checkmark Buzzer, set buzzer alarm hold time
Fig 4-28 System Configuration-Alarm Out
34 | P a g e
QT428 User Manual