Wiring Diagram - Marksman M9A Installation Manual

Wiring Diagram

4-Pin
Tan
2-Pin 4-Pin
White White
5-Pin 4-Pin
White Blue
4-Pin
White
To Data
Module
34
Red Wire: +12V Power
Black Wire: Negative Power
Blue Wire: Zone 4 Ground Trigger
Green Wire: Warn Away Ground Trigger
White Wire: (-) 200mA Programmable Output
Yellow Wire: (-) 200mA Ignition 3 Control Output
Black/Green Wire: (-) 200mA Timer Control Channel 4 Output / Key Sensor Output
Gray Wire: (-) 200mA Channel 3 (Trunk) Output
Pink Wire: (-) 200mA Programmable Output
Orange Wire: (-) 500mA Grounded Output when Armed
Blue Wire: Zone 2 Instant Trigger Ground Input
Green Wire: Zone 3 Negative Door Pin Trigger Input
Violet Wire: Zone 3 Positive Door Pin Trigger
White/Blue Wire: (-) Instant Start and Turn Off Input
White/Black WIre: (-) Negative Safety Shut Down Input for Hood Pin Switch
Black/White Wire: (-) Neutral Safety Switch Input and (-) Remote Start Toggle Switch Input
6-Pin 8-Pin 3-Pin
White/Violet Wire: (+) Positive Safety Shut Down Input for Brake Switch
White Black Black
White/Red Wire: Tach Signal Input
(See Door Lock
Connections)
6-Pin 2-Pin
White Blue
Violet Wire: Starter Output
Red Wire: +12 V Input (Battery)
Red Wire: +12 V Input (Battery)
Yellow Wire: Ignition 1 Output (Must Connect)
Pink Wire: Ignition 2 Output
Brown Wire: ACC / Heater Output
Black Wire
Black Wire
Black Wire
Black/White Wire
Red/White Wire: Parking Light Relay Power Input
White Wire: Parking Light Relay Output
Black Wire: Ground To Vehicle Frame
Brown Wire: Positive Output to Siren
Red Wire:
Dome Light Control Output (Factory Default Setting) or 2 Step Door Unlock or
Factory Security Disarm Signal Output or Ground Output During Start (Crank)
Horn Output (Factory Default Setting) or Factory Security Rearm Signal Output or
Start Status (Shock Sensor Bypass Control) Output
Red Wire: +12V Input
3A
Valet Switch
20A
20A
15A
Cut this Wire and
Ground it for Ground
Trigger Parking Lights