Advertisement
Contents
Component Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-16
Programming the Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Alarm Feature Programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18-20
Remote Start Operation/ Programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21-27
Speciality Features and Testing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28-33
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Installer Warnings!
This remote starter with alarm system is designed to be installed on fuel injected vehicles with an automatic
transmission ONLY.
• Do not plug the 8-pin or 5-pin wire harness into the alarm control module before you begin installing the
alarm. The wire harnesses must be plugged into the alarm control module after all connections are made.
Failure to follow this procedure could cause some confusion with transmitter operation and or alarm function
operation.
• Never install this remote starter on a manual transmission vehicle.
• This system must be installed and wired through a safety switch so it will not start in any forward or reverse
gear.
• Some automatic transmission vehicles (mainly older GM vehicles with a purple starter wire) have a
mechanical-type park safety switch instead of electrical safety switch. The mechanical type does not interrupt
the starter circuit when the transmission is any gear and does not offer the 100% level of safety required for
remote starting purposes. Therefore, our system should never be installed on any vehicle that uses a
mechanical type park safety switch.
• Once you install this system, you must verify that the vehicle will not start in any forward or reverse gear.
Regardless of the type of vehicle.
• Read operation manual for operating and programming routine.
• Do not install any component near the brake, gas pedal or steering linkage.
• Some vehicles have a factory installed transponder immobilizer system that can severely complicate the
installation. There is possibility that this system can not be installed on some immobilizer equipped vehicles.
• Most vehicles have an SRS air bag system. Use extreme care and do not probe any wires of the SRS system.
• Disconnect the car battery before connecting work on the vehicle.
• Use conventional crimp lock, bullet on any wiring. Poor wiring, i.e. taped joints will possibly introduce
unreliability into the alarm system and may result in false alarms or incorrect operation.
• Install wiring neatly under carpets or behind trim to prevent possible damage to wires.
• For the wires that operate at currents more than 10A, we suggest soldering all connection points. Do not use
crimp lock type connectors or wire nuts.
2
Hide quick links:
Advertisement
