Speciality Features And Testing - Marksman M9A Installation Manual

Shock Sensor Testing and Adjustment
Step 1
OF F
ON
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the Off position
the third time.
Step 4
A light impact to the vehicle will
activate the warn-away (first stage
shock sensor / Zone 1), the system
will emit a short chirp.
A more forceful impact will activate
the full alarm (second stage shock
sensor / Zone 4), the system will
emit a long chirp.
28
Step 2
9X + 1X (Hold)
3X
Before 15 seconds has passed, push
and release the valet switch 9 times
then push the valet switch a tenth
time and hold it down until 5 short
chirps/beeps and 1 long chirp/beep
is heard then release it.
Step 5
Decrease
Using a small screw driver to adjust
the sensitivity. Turn the screw to the
"-" direction decreases the
sensitivity. Turn the screw to the "+"
direction increased the sensitivity.
Continue to test the shock sensor
until the proper sensitivity is
reached.
Press and release the (
buttons at the same time twice to
enter the Shock Sensor Test mode,
there will be a 2 chirp confirmation.
Increase
Press the ( ) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
Step 3
+
)
Step 6