Table of Contents
Advertisement
DT4572 X-Band Down Converter
Redundant System Operation
A.2 B
ACKUP
The "Daisy Chain" terminates in the backup Converter. The backup Converter has a
microprocessor which performs fault detection, self reconfiguration and the logical
switching functions. If the backup Converter does not have a fault, it will assume the
frequency and attenuation of the faulted converter and compensate for the chain losses.
This capability is accomplished through the operation of the High Speed Bus (HSB) and
the online converter detachable switch modules.
A.2.1 H
S
IGH
PEED
In the "Daisy Chain" configuration, the backup Converter communicates with the online
units through the high speed interface bus (HSB). The backup Converter is able to detect
faults and reconfigure itself to replace the faulted converter. The HSB interface also is
used in the backup Converter to monitor configuration changes made to an online
converter. Changes in frequency, gain, or polarity are immediately entered into the
backup table as well as information from new online units. The high speed bus does not
interfere with the remote serial communication link access to any of the converters in the
chain.
A.2.2 D
ETACHABLE
Comtech EF Data's converters are designed with a detachable Input/Output Module
(IOM) which contain the signal path connectors. The IOM is utilized for single thread
operation, or for testing of the unit.
For redundant "Daisy Chain" operations, the on-line Down Converters are provided with
a detachable Receive Switch Module (RSM) replacing the IOM.
A.2.2.1 D
C
OWN
ONVERTER
The RSM contains IF switches for input/output looping of the signal. Options for the
RSM include SMA connectors for the RF Input signal, and 50Ω or 75Ω BNC connectors
for the IF.
C
ONVERTER
B
(HSB)
US
M
ODULES
S
WITCHING
32
Rev. 0
MM/DT4572.IOM
Advertisement
Table of Contents
Troubleshooting
