Omron CS1W-V680C11 User Manual page 37

 Creating I/O Tables
Always create the I/O tables after turning ON the PLC power supply.
The I/O tables can be created from a CS/CJ-series Programming Console or a CX-Programmer
(Support Software used to control a PLC, e.g., to create programs or change operating modes).
 Initial Settings
1.
Make the settings in the words allocated to Special I/O Units in the DM Area.
For information on setting the Special I/O Unit words in the DM Area, refer to Parameter Settings in DM Area on page
93.
p. 93
Peripheral port
Programming Console
Peripheral port
Programming Console
SECTION 2
CS-series ID Sensor Units
RFID System
User's Manual
35