Power Off Your Projector - Proxima M1010X User Manual

Power off your projector

1. Press the power key at the rear control
panel or the remote controller, the "Power
off?" message displays. Message.
2. Press the power key again in 4 seconds
after the "Power off?" message prompted
to you. The POWER light indicator flashes
red while the cooling fan continues running.
(You may set up noise level and speed of
the fan.) Unplug the power cord until the
fan stops running. Failure to do so may
shorten life cycle of your projector or lead
to power on failures or operation abnormali-
ties.
3. The POWER light indicator stops flashing
once the projector has been cooled down to
ready for power on again.
To maintain the life cycle of the lamp,
power off your projector after it has
been on for at least five minutes.
Do not use your projector without
stop. as it may hurt the life cycle of
your lamp. Power off your projector at
least once every 24 hours and have
it idle for an hour.
Note:
● If the "On Start" option is set to "On" your projector will power on once it is connected to an AC
power socket.
● Speed of the cooling fan varies with internal temperature of your projector.
● Do not place your projector in any box before it is fully cooled down.
● In case the POWER light indicator flashes or turns red, refer to the "Light indicator status" for
instructions.
● The POWER light indicator flashes when the lamp is cooling down. Do not power on your
projector at this time. Power on your projector only after the POWER light indicator turns red.
● Unplug the power cord after your projector has been turned off. The fan stops running now.
● The POWER light indicator turns red when your projector is ready for power on again. It takes
less time to restart your projector after it was powered off in the standard power off procedure
than that of the non-standard one.
26
Basic operation
VOL- VOL+
Power off?
"Power off?" message disappears
in 4 seconds.
VGA
Power IN
P/PR G/Y
key
MONITOR OUT
VIDEO S-VIDEO AUDIO AUDIO AUDIO RS-232C
IN1 OUT IN2
360.2
Power key
B/PB H/HV V
R/C R
IN O