Table of Contents
Advertisement
Wired connections
For projecting through a wired network, you need to connect the projector and your
device to the same local area network (LAN).
Projector
Setting up a wired network for the projector
If you are in a DHCP environment:
If your projector is in a DHCP environment, you do not have to manually set the IP
address. Follow the steps below to configure the wired network settings for the projector
in a DHCP environment:
1.
Connect the projector to a local area network via an RJ45 cable.
2.
Turn on the projector.
3.
Press MENU to open the Advanced Menu.
4.
Highlight Network and press OK.
5.
Highlight Wired LAN and press OK.
6.
Highlight DHCP and press OK.
7.
Select On and press OK.
8.
Highlight Apply and press OK.
9.
Re-enter the Wired LAN page and check if the IP Address, Subnet Mask,
Default Gateway, and DNS Server have been automatically configured. Make
sure the Status is Connect.
If the IP Address still does not appear, contact your network administrator.
If you are in a non-DHCP environment:
If your projector is in a non-DHCP environment, you need to manually set the IP Address,
Subnet Mask, Default Gateway, and DNS Server. Follow the steps below to configure the
wired network settings for the projector in a non-DHCP environment:
1.
Repeat step 1 to 5 described in
2.
Highlight DHCP and press OK.
3.
Select Off then press OK.
4.
Contact your network administrator for information on the IP Address, Subnet
Mask, Default Gateway, and DNS Server settings.
5.
Enter the projector's IP Address, Subnet Mask, Default Gateway, and DNS
Server and assign the values as needed.
6.
After finishing the settings, highlight Apply and press OK.
6
Preparation
Internet
Wired LAN
RJ45 cable
"If you are in a DHCP environment:" on page
Laptop computer
RJ45 cable
RJ45 cable
Desktop computer
6.
Advertisement
Table of Contents
